A well prepared surface is important to ensure that the product works effectively. To start with, the surface should be dry and clean. If there is any dust, debris or shavings, these should be carefully swept away from the area. It is recommended that you use a good quality IPA cleaner to remove all surface contaminants such as paint flakes. Never use petrol, lighter fluid or methylated spirits for this task because these will leave behind a thin, greasy residue. The prepared surface should also be above 10°C. Sealing of Porous Surfaces When working with a porous surface, it should be suitably sealed before application. This will prevent water from attacking the adhesive. A toluene based primer would work well. Our own products are highly recommended for this task. With your chosen primer, apply a very thin coat to the surface using a suitable paintbrush and then leave to dry. Tape Application When the primer is dry, take the length of anti-slip tape and peel back part of the release liner. Press the adhesive firmly onto the prepared service, slowly peeling back the liner as you apply the tape along the length of flooring, stair or surface you are working with. Ensure that the tape is not too taut. When the tape is applied to the surface, press it down firmly using even pressure. A decorating roller would be perfect for this task. The edges should then be sealed using an ‘edge fix’ product or something similar to maximise the lifespan of the tape. You only need to apply a small amount of edge fix to either side of the tape. A tiny bead along the length of the tape is best, allow edge fix to dry. Once the tape has been installed using the recommended installation methods, it can be used and walked on as part of everyday operations and the adhesive will be fully set within 48 hours.
